SAFETY
Cable clips are widely used to make end terminations. The clips are available in two basic designs; the U bolt and the cuff. The efficiency of both types is the same. When using U-Bolt clips, extreme care must be taken to ensure they are connected correctly; i.e. the U-bolt should be applied so that the “U” section is in contact with the dead end of the rope.
The working load limit is the maximum load that must be applied to the product, even when the product is new and when the load is applied uniformly – straight line traction only.
The rated capacity of a multi-leg sling is directly affected by the angle of the sling leg to the load. As this angle decreases, the stress on each leg increases with the same load. If the sling angle is known, the capacity can be easily determined by multiplying the vertical capacity of the sling by the appropriate load angle factor from the table to the right.
For all steel rope, the best time to begin taking proper care and handling measures is immediately upon receipt. Upon arrival, the rope must be carefully checked to ensure that the delivered product matches the description on the labels, order forms, packing sheets, purchase order and invoice.
As cable is a machine with many moving parts, it requires careful installation and breaking procedures for maximum safety and long life. After proper installation, allow the cable to run through an operating cycle at a very low speed.
For all steel rope, the best time to begin taking proper care and handling measures is immediately upon receipt. Upon arrival, the rope must be carefully checked to ensure that the delivered product matches the description on the labels, order forms, packing sheets, purchase order and invoice.
Common terms defined.
Currently, widely used steel grades are IPS (Improved Plow Steel) or EIPS (Improved Plow Steel), sometimes also referred to as XIPS, XIP, EIP. Stainless steel grades 302/304 and 316 are the most common.
Two of the most important prerequisites for inspecting cable are technical knowledge and experience. Check the general condition of the cable. Also, look for localized damage and wear, especially on cable accessories. Inspect all parts that come into contact with the cable.
Due to tolerances in diameters and the variety of cable constructions, it is difficult to calculate the maximum length of cable that can be wound on a reel or drum. The following formula can be used to calculate the capacity of windlasses with at least one cable diameter below the flange diameter, for clearance (“X”). Calculated spool capacities are based on uniform rope winding on the spool.
Like any machine, it needs proper care and maintenance for optimal safety and long life. For a better understanding of wire rope, we highly recommend the Wire Rope Users Manual by the Wire Rope Technical Board.
Anyone using this catalog is responsible for reading and understanding all warnings, instructions and other information listed below and in the rest of this book. Warnings may be found under or directly adjacent to the product description of the items.